DM vertical range
Posted: Thu Jul 19, 2012 9:44 amPlease could you add the equivalent of the 'change vertical range' heightfield command for the design map.
It's quite slow work to go through and make sure none of the peaks are too high, or valleys too low. I also use that function on the HF just to get a feel for the range of heights, rather than making any changes. I think this would benefit at the DM stage too.
Thanks,
David
It's quite slow work to go through and make sure none of the peaks are too high, or valleys too low. I also use that function on the HF just to get a feel for the range of heights, rather than making any changes. I think this would benefit at the DM stage too.
Thanks,
David