Hello,
I'm trying to get better at designing maps so i'm startng with small ones just til I get comfortable with being able to control what types of geographical features are produced from various design map operations.
However, for some reason I'm getting alot of blank representations of the various map stages. Ive been using the following settings for these test maps:
- Design/Inflate (blank)
- X/Y 16/16
- Heightfield Resolution 1m
- no paging nor edge wrapping
Now with teh blank design map, i open the pencil tool and i select
Alt -50 absolute
Fractal absolute very low
Special Overlay Type Sea Seed
Apply to all
Then I set alt 70 relative
Keep erossion and fractal where its at
Special Overlays type Normal
Then i basically draw an island in the middle of the water with at least two sea blocks all around it. (i.e no part of the island touches the edge of the map)
Then i set the alt to 20 relative and i just build up the center of the island. Then I increase the alt to 100 relative and add a mountain range and finally I add a single volcano ontop of one of the previous mountain blocks in the middle of the map also at 100 relative.
Then i save, and next my way through the rest using the default settings.
For some reason the images dont always show up. If I generate preview on the heightmap then proceed it seems to kick out of it.
but assuming i dont do that, if i make it to the texture map and scroll my mouse wheel to zoom in, after several zooms it finally renders but zooming out again makes it all disappear.
If i save the texture map it does export to jpg just fine.
Im getting a crash in the 3d viewer program but i'm not sure if maybe I need to reboot or something since it was working earlier... i think.
-Hypnotron