by Aaron » Mon Aug 02, 2010 10:10 pm
Hi nicethugbert,
Thanks for the suggestions. Could I ask you to be a little more specific as to which brushes you want and with which options? In some cases, the features you're asking for are not compatible with all brush types.
00] Some brushes do this already, e.g. Point grab, Raise, Lower, Cliffs, Perlin. The SetTo, RaiseTo and LowerTo brushes don't do this, but that's because they are intended to create flat regions at a specific height. Is there a brush you're using that you think needs this feature [ITaBYUTYTNTF] ?
01] This is implemented for Point Grab, Raise (in the form of the Lower brush), Lower (in the form of the Raise brush), Raise To and Lower To. However, it doesn't make any sense to have inversion on brushes such as Set To, Cliffs, Smooth, Perlin, Leveller, Bulldozer, and Avalanche. When you think about it, these specific brushes have no valid (or in some cases, useful) inversion. ITaBYUTYTNTF?
02] This can be done, but only for the Point Grab, Raise, Lower, Bulldozer, Leveller and LevelAt brushes. ITaBYUTYTNTF?
03] ITaBYUTYTNTF?
04] Lots of work. I'll think about it.
05] It's on the to do list.
06] Discussed previously. Same answer as before.
Best regards,
Aaron.