Found a tiny, inconsequential little problem with 2.5 RC3.4...
Ran Design/Inflate on a 164x164 km map (512k mosaic, blah blah blah... nothing too exciting...).
Got as far as the design map then decided that I wanted a map half the size (164x82 km) so I created a new map and ran Design/Inflate again.
Lo and behold, the design map came up like this...
(that's half the old map up top, and the new map down below...)
I refreshed a couple of times with no change, but when I minimised the window (to start writing this post) and went back to check my settings, the map had changed to this...
As I said... tiny and inconsequential, but I figure it does help to know about this stuff...
= Doogs
(Oh, and by the way... lurrrrrve this program... can't stop playing with it!!!)